Ammonia As a Refrigerant: Pros and Cons

ammonia as a refrigerant photo (green building )[Editor's Note:  If you want to boost your HVAC career check out our interactive infographic: "HVAC Career Development Map"]

As fewer and fewer CFCs and HCFCs are available for use as refrigerants, look for ammonia to become more popular as a replacement. According to ASHRAE and the International Institute of Ammonia Refrigeration (IIAR), ammonia is a cost-effective, efficient alternative to CFCs and HCFCs that is also safe for the environment.

Ammonia (chemical formula NH3) is a gas comprised of two other gases — nitrogen and hydrogen. Whether found in nature or made by man, ammonia is colorless but has a sharp, pungent odor. Ammonia, frequently used commercially in large freezing and refrigeration plants is also called “anhydrous ammonia” because it contains almost no water (it is 99.98% pure). Household ammonia, by comparison, is only about 10% ammonia by weight mixed with water.

As a refrigerant, ammonia has four major advantages over CFCs and HCFCs:

  • An ammonia-based refrigeration systems costs 10-20% less to build than one that uses CFCs because narrower-diameter piping can be used.
  • Ammonia is a 3-10% more efficient refrigerant than CFCs, so an ammonia-based system requires less electricity, resulting in lower operating costs.
  • Ammonia is safe for the environment, with an Ozone Depletion Potential (ODP) rating of 0 and a Global Warming Potential (GWP) rating of 0.
  • Ammonia is substantially less expensive than CFCs or HCFCs

There are two key disadvantages to using ammonia as a refrigerant:

  • It is not compatible with copper, so it cannot be used in any system with copper pipes.
  • Ammonia is poisonous in high concentrations. Two factors, however, mitigate this risk: ammonia’s distinctive smell is detectable at concentrations well below those considered to be dangerous, and ammonia is lighter than air, so if any does leak, it will rise and dissipate in the atmosphere.

Next Steps:

Matt Cardin
Goodway Blogging Team


HVAC Career Development Map2 photo (green building )
Looking to boost your HVAC career?

Download our 2012 HVAC Career Development Map or visit our Learning Center.

pixel photo (green building )

7 comments


  • don

    What is the percentage of refrigeration plants and refrigerated warehouses that are using ammonia refrigerant?

    May 21, 2011
  • Tim

    In the research that I did, most large scale industrial refrigeration uses ammonia refrigerant. So 80%-90%. It’s use in commercial HVAC applications is also growing.

    May 23, 2011
  • Dipankar Ghosh

    How is the Oil& Gas Industry looking at ammonia as a replacement of CFCs and propane refrigeration? What about using waste heat (from GT power plants) to produce refrigeration using absorption refrigeration process using ammonia, which can be used for hydrocarbon condensate recovery and other chilling requirement for air conditioning etc. ?
    Can any body throw light on this?

    July 7, 2011
  • Tim

    Sounds like an interesting discussion thread. Sounds very similar to some co-generation concepts being used. Anybody want to add comments? Thoughts?

    July 25, 2011
  • Mike

    Hello, I’m new to the refrigerant recovery industry and I was hoping somebody could give me some insight on how to easily identify ammonia tanks from other refrigerant tanks?

    July 29, 2011
  • [...] However, only qualified technicians should handle ammonia refrigerants, because working on an ammonia refrigeration system is different than working on other refrigeration systems, he says. For example, while copper tubing is commonly used in smaller HVAC systems, it should never be used in an ammonia refrigeration system. (Editors Note: Check out our popular post on this topic: “Ammonia As a Refrigerant: Pros and Cons“). [...]

    March 19, 2012

Leave a comment


Name*

Email(will not be published)*

Website

Your comment*

Submit Comment

Just Venting is powered by Backbone Media, Inc.